I purchased the Loud Sub, and I had set the settings and saved them in a session. Then, when I turned the sub back on, the settings were distorted in the sub zone. I also don’t understand why, if I try to save the session with other settings or take another measurement, the next session retains delays and phases that are sometimes strange. I can’t figure out the exact procedure.
Ive found the problem.. When the button of correction active on the arc hardware is on the measurement and also the correction is compromised… I dont know if its abug or sonething else.. Can you check this? Thnks
hi again…i’ve done probably an error …i’ve used ik arc hardware correction togheter the iloud sub…perhaps this is my error…iloud has integrated the same dsp of ik arc 4? thnks