Tonex Board static and lag - PC interface

How do you eliminate the static and crackle and pops when using ToneX Board as a PC instrument interface? I am running Windows 11. Also, there is a considerable lag that I am not able to eliminate. Any tips? Does everyone just run their ToneX Board through some other interface like Volt or Focusrite?

If you are on Windows, did you install the Tonex ASIO drivers found in the Product Manager->Hardware? If so, make sure you are using them in your DAW device settings.

Aside from that, in the Tonex ASIO settings (the icon is near your desktop clock in the taskbars) you can decrease the ASIO buffer to decrease the latency as well. Just keep in mind that your PC needs to keep up with the lower buffer or you will get crackling noises, how low you can set it depends on now powerful your professor is and your other PC specs.

I don’t recall if I downloaded them. I will double check tonight. Thank you.

This seemed to help considerably on the clarity. It’s still something where I will want to listen to the sound from the ToneX board instead of through my DAW. I suppose it is no different than recording on tape. If you listen to the output of a tape recording Vs. a monitor mix you would get a similar lag.

Glad to help! I don’t know if I got your point correctly, but by default you will hear the Tonex Board sound directly, just make sure to disable your DAW input monitoring in the Tonex track so the monitoring is not doubled (maybe that’s whats causing the strange sound)