I have an iRig Stomp I/O using Amplitube on Windows 10. When in preset switching mode, about 1/2 - 2/3 of the presets of the 25 or so I have, will typically switch fine without any sound corruption. But there are some I switch to that will immediately corrupt the sound. I go into Audio Settings, change the buffer size (doesn't matter if I change it up or down) and the sound goes back to normal, which is odd that I can lower the buffer size and it will be fine. Later I may switch to another preset, and it may or may not corrupt the sound, remedied again by the switching the buffer size. The buffer sizes, even to the smallest, seem fine if staying on the same preset, but will corrupt at times only when switching presets with the Stomp I/O. I don't seem to experience any other sound corruption except through this operation. I've tried using the 1024 buffer size, and it just doesn't make any difference. My laptop has plenty of processing power and 32 GB of ram, and I can only imagine it must be a problem in the Windows Exclusive Mode operation. Any thoughts on how to prevent this issue altogether without having to worry about manually changing the buffer size each time after it does happen?
Thanks
