I am trying to update the firmware on the older iRig Pro. The firmware updated finds and recognizes the device, however it errors out every time as it's trying to update. I tried restarting, closed and reopened updater, and disconnected and reconnected the device. I receive the following message. Any help would be appreciated.
Thank you.
iRig Firmware Updater - 1.11 (8D03) 64-bit
Looking for IK Multimedia iRig interface...
Found HID device VID:0x1963, PID:0x000A
iRig PRO DFU (USB Device) was found.
Read PCB Rev: 3
Read 64 EEPROM bytes.
Current EEPROM data:
A1 18 12 34 19 63 00 0A 00 04 99 73 03 00 00 01
00 06 0E 08 01 09 0B 36 00 00 00 00 00 00 00 00
BC 0E 56 78 00 01 00 06 0E 08 01 09 0B 36 00 00
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
Firmware is updating.
The operation could take several minutes to complete, please wait...
Do not disconnect while updating the device firmware.
HID command sent.
Found HID device VID:0x1963, PID:0x0009
Device Release Number: 0x0100
File open error!
Firmware update failed with error code: 0x1
File is not accessible.
Ended in 0.000 seconds.
ERROR: Firmware update failed!
Please close and restart the application or contact IK MULTIMEDIA technical support
HID communication terminated.
Firmware update finished with ERRORS!
ERROR CODE: 1
Now you can disconnect iRig PRO.
