AmpliTube + iRig on ipad

[pim999]

Hi,
I
I have an issue when I launch AmpliTube after connecting an interface (iRig pro I/O or micro amp). Sometime the interface is not found (no sound in the headphone).

This issue occurs with or without Audiobus, but it doesn’t occur every time (but more than 3/4 of the time).

Thanks in advance for your answer.
Kind regards,
Sylvain.

[Peter_IK]

Hi, since other users have not chimed in with suggestions I'd suggest contacting IK Support at http://www.ikmultimedia.com/contact-support for official direct technical support if you have not done so already. Thank you.

[pim999]

Thanks Peter. I did so this week.
Kind regards.
Sylvain.

[rimowals.m]

Hi,
i have similar problem (amplitube cs, irig pro i/o, ipad pro ios 12.2) - after few minutes of playing there was no guitar sound in headphones. All restarted, all bateries replaced but still no sound. Drums (loop drummer) can hear, connected to pc and amplitube 4 still works, but with ipad and amplitube cs there is no guitar sound (guitar is connected to irig).
Any known problem with amplitube cs?

[Peter_IK]

Hi,
i have similar problem (amplitube cs, irig pro i/o, iPad pro ios 12.2) - after few minutes of playing there was no guitar sound in headphones. All restarted, all bateries replaced but still no sound. Drums (loop drummer) can hear, connected to pc and amplitube 4 still works, but with iPad and amplitube cs there is no guitar sound (guitar is connected to irig).
Any known problem with amplitube cs?

I would recommend reporting your issue to IK Support to get direct official tech support. Thank you.