I was told the same information from UG-tech staff to do those same 3 steps but with the Blueboard.
I tried to do the same 3 steps with my iRig stomp and NO! it does not work. further more the info I was given is cropped and pasted below. Also my initial start up issues were a cause of a bad power cord. Not sure if IK wants to send a new one to me? or what I should do? I have to use the usb1 usb 2 cable for power.
So I am not sure what else to do, I did the 3 steps as suggested with the Stomp i/o and NO GO!
So I am about to buy a blueboard but would prefer not to.. maybe since I got a bad power cord I may have a bad unit? IK is not good at timely responses so not sure if my unit is bad faulty? or what I should do about a return or replacement. the vendor suggested I reach out to IK ?
below is a quote from UG tech staff..
-----------------------------------------------------------------------------------------------------------------
Hello,
Our staff member has given you the right advice, but I'm afraid you didn't quite follow it. The recommendation was to buy iRid Blueboard, not iRig Stomp I/O. You can try to set it up using this instruction for Blueboard:
1. Get the iRig Blueboard app (https://itunes.apple.com/us/app/irig-bl ... 33714?mt=8) and connect your Blueboard to the app. Be sure it's connected before proceeding to step 2.
2. Go to Tonebridge, scroll the Featured screen down, open the External Pedal Interface.
3. Tap “Set up...“ on any of the actions in the list, and then press any button on the Blueboard. The button should assign to the action, and you will be able to control the app with the Blueboard.
If this doesn't work - I suggest you return your Stomp device and Blueboard as advised. It's also 2.5 times cheaper, you can get it for $100.
Thanks for being with Ultimate Guitar!
Don't hesitate to contact me if you need support in future!
Best regards,
Khristian Yungblyut
Ultimate Guitar Support Team