[RESOLVED] Amplitube CS stops working, can't restart

[ThorntonRelics]

Hi, I just got a new iRig Stomp I/O and a brand new iPad. Got Amplitube CS loaded and turned everything on. I played for about 5 minutes and then everything just stopped working. No sound. The screen is still showing the pedals etc. but nothing works I shut everything off and restarted it all but still no sound or ability to control anything. Any help solving this mystery would be greatly appreciated.

[Ryan_IK]

This does sound odd. While I would suggest checking with IK Multimedia technical support at the link below. Make sure to check your connections. Make sure nothing is loose or intermittent. If you have protective casing on your iOS device, try removing this to see if this helps.

https://www.ikmultimedia.com/contact-support/

[ThorntonRelics]

Thanks Ryan, What I ended up doing was a hard shut down of the iPad and then re-boot everything. It worked well ever since. (Must have been the Twilight Zone or something). I had seen another post somewhere when I was doing all my pre-purchase research and saw where someone had complained about the same thing but couldn't find the post to see the solution. Luckily I got it working again.
Thanks again!