When I switch on the UNO Synth everything seems to work.
It starts with the oscillator row activated, so I can twake the Wave1, Wave 2, Tune 1 and Tune 2.
When I swith to another row, like the Filter, the envelope or LFO row, that can be done.
However I cannot switch back to the Oscillator row anymore. I can only switch between the other 3 rows.
The only way is to switch the unit off, and turn it on again. Then it starts again with the oscillator row.
Is this a common think, or just my unit? Could this be fixed by a firmware update or so?
Edit: I just sent a request to the support department.