AXE I/O - No Effects or Control

[Peter_IK]

Hello!
Does anyone know whether the Monitor knob should have effect on the Amp Out or not?
I simply cannot make such a setup where I can get processed sound on the Amp Out and by using the Monitor Knob I can set the amount of dry and processed sound. Checked the manual quite a few times but I did not find anything about this.
Regards,
Zsolt

The section of the manual that explains each of the items on the front panel states about the Monitor dial:

This control works both for Outputs 1-2 and Headphones.

[Yoss-X]

I see, thanks for the information. So this makes the Amp Out quite a bit less useful. For me, at least..

[Peter_IK]

I see, thanks for the information. So this makes the Amp Out quite a bit less useful. For me, at least..

You're welcome. Yes, if you aren't using Amp Out's main purpose (reamping) then you might not get as much use out of it. There are other outputs, though, that will pass the effected signal.

[Yoss-X]

Yes, I know. But I was happy to see that AXE has Amp Out so I can connect it to my amp without further complications. Actually, I tried the "standard" outputs (1/2) connecting to my amp and I experienced no problems (I have a Peavey VK212 combo and it has a second imput for higher signal level sources) but I thought it's better if the output is designed for amps. I am a beginner so it might be that I get some things wrong about AXE, but anyway I love the sound of it used together with AT 5 I keep playing with it and we'll see Thanks the help anyway

[Raimond01]

I had the same problem. After installation of the amplitube update and re-setting the midi settings all was ok again.