I have my signal chain like this:
On StompA I have 2x diode overdrive pedals like this:
I have all room mics completely to 0 and amp reverbs also set to zero.
With this setup, however I hear reverb! I tried changing the Cabinet room also, but no result.
If I choose Mono input instead of stereo it gets a little better, but it's not without reverb.
If I switch off both diode overdrives, reverb is gone.
Any idea how to kill reverb without killing the sound by switching off the overdrives?
I tried other signal paths and also seperating overdrives to stomp A and B respectively, but no luck.
Thanks in advance
