by stroonz58 » Thu Feb 25, 2021 6:56 pm
Hi all,
I guess I have to apologize for being a little annoyed that I updated a driver and couldn't get my Stomp I/O to work again, [mod redacted again - please review the rules, this time specifically those about moderation and general rules too]
Anyway, I got a rather quick reply from an IK support rep earlier today and he said he never saw the problem that I stated. He suggested I use a program to capture the screen as I was installing the driver so he could what I meant. I did and just before sending it, alight bulb went off. Let's see if my iOs device sees it because I've never had a problem with that ever. Tried it and it didn't work on Amplitube iOs either. So now I'm thinking my Stomp I/O is a goner.
Then I remember that recently I tried using it as a MIDI controller in Standalone mode. This requires using the power supply since it's not using bus power. When you plug the power supply in, you need to hold down the first stomp button until the button lights flash and the Gain & Volume LEDs stay red. So I thought maybe it's still in standalone mode even though I disconnected the power supply. In the manual, it says to hold the first stomp button down when disconnecting to revert back to normal mode. Evidently, that doesn't work and you really can't tell once you unplug it! So I did the procedure again and the 4 stomp lights flashed 3 times but the Gain & Volume LEDs did NOT light up. So I figured now it's in normal mode. Tried it with both my iPad and PC and it worked fine.
Just though I'd put this out there in case anyone else can't get their pedal to connect to their device.
And again, sorry for bending the rules but it get frustrating when you're troubleshooting gear and software more than enjoying.