Hi guys ,
I am new here
And I am trying to Connect Piano Roland FP 30X - it has 2 x Jack mono L and R output (phantome not needed)
And Rode Nt01 with is an condenser miceophone (phanton needed)
My plan was to Connect one of The Cables Big Jack from Piano by output to IRig 1 channel,
And microphone by XLR to another .
Microphone need a phantome power , Piano doesnt .
So if I can start a +48 V phantom mode , I am afraid I can do something with piano. Sending 48v into it .
On This forum I found only this :
„ I got them all resolved by getting the following:
MIDI cable (male - male) from digital piano to IRig midi adapter and plug into IRig MIDI in.
Then a dynamic vocal microphone with XLR-XLR cable to IRig instrument input.
Then a TS unbalanced male to male cable from keyboard out (mono) to IRig instrument input.
And, finally, got a 9V AC/DC adapter with polarity inverter so it can change -/+.
The recording sounds are very cleared in Zoom & GarageBand. So far so good! ”
But in this case they have dynamic mic witch doesnt need a phantom .
Should I as well use MIDI cable from Piano out besides Mono Jack from Piano output .
What is a correct way to Connect it together.
And what about polarity on Dc/ac adapter?
Thanks for help