Hooking up iRig Stomp I/O into Marshall JCM 900

AXE I/O, AXE I/O Solo, iRig Stomp I/O, Guitar and Bass Audio Interfaces/Controllers, iRig Keys I/O and the iRig Keys family of MIDI controllers

Hooking up iRig Stomp I/O into Marshall JCM 900

Postby C_berg1980 » Wed Oct 23, 2019 3:31 pm

Hello, could someone provide me some assistance/instruction on the correct way to hookup my iRig Stomp I/O into my JCM 900 amp/combo its the 50W Hi Gain, Dual Reverb, model 4502? I'm not sure if I should bye-pass the preamp section or go through the effects loop. I would like to know how set up the Stomp into my JCM to achieve best sound possible. I'm also nervous about incorrectly routing cables because I don't want to messing my amp up by frying a circuit or blowing tubes. Any help will be very appreciated.

Respectfully,

Cody
C_berg1980
 
Posts: 16
Joined: Sat Jan 20, 2018 4:03 am
Location: Ohio

Return to Interfaces & Controllers