by Ryan_IK » Wed Nov 14, 2018 6:29 pm
Hey tombright,
Thanks for your post.
While I don't have any picture to offer. There are a couple ways to set this up depending on the desired outcome. I would suggest one of the two ways described below.
1) Connect the RC-3 between your iRig 2 and Guitar. This will allow you to loop your Guitar before it goes to the AmpliTube app. This can allow for some unique tweaking of sounds.
2) Connect the RC-3 between your iRig 2 and Amplifier. This will allow you to loop your Guitar after its gone through the AmpliTube app. This will allow for less tweaking since your looping sounds with FX on them already, but this can result in a unique performance by combining different tones.
Hope this helps!