iRig HDx wet signal out issues

[OffWorld86]

This might be a bit of a ramble but just trying to be thorough with my question.

I bought a brand new iRig HDx through Apple UK and it doesn't appear to be working as intended.

While I can get an input signal and record into Garageband iOS the monitoring doesn't work as described.

I can only get a dry guitar signal out through the headphone and amp out but not a wet mixed output as I should through any combination of settings.
I've followed a few guides online where it shows a wet signal going out to both headphones and amp but following these I have still had no luck with getting this outcome.

All audio cables have been checked straight into my amp, tried two sets of wired headphones both of which work with my other devices and even tried the original usb c to usb c cable that came with my iPad pro 11 inch 3rd generation.
All software is currently up to date iOS 17.2, Garageband, ToneX, and JamUp Pro.

Even with thorough testing I cannot get a wet guitar signal out of this device, what could be the issue here any help would be greatly appreciated?

Thank you.

[LafayetteJacob]

This might be a bit of a ramble but just trying to be thorough with my question.

I bought a brand new iRig HDx through Apple UK and it doesn't appear to be working as intended.

While I can get an input signal and record into Garageband iOS the monitoring doesn't work as described.

I can only get a dry guitar signal out through the headphone and amp out but not a wet mixed output as I should through any combinationsuika game of settings.
I've followed a few guides online where it shows a wet signal going out to both headphones and amp but following these I have still had no luck with getting this outcome.

All audio cables have been checked straight into my amp, tried two sets of wired headphones both of which work with my other devices and even tried the original usb c to usb c cable that came with my iPad pro 11 inch 3rd generation.
All software is currently up to date iOS 17.2, Garageband, ToneX, and JamUp Pro.

Even with thorough testing I cannot get a wet guitar signal out of this device, what could be the issue here any help would be greatly appreciated?

Thank you.

Incorrect monitoring settings. This is the most likely culprit. Double-check your monitoring settings in both Garageband and the specific amp apps you're using (ToneX, JamUp Pro). Make sure that "Direct Monitoring" is not enabled for your guitar input, as this would bypass the effects processing altogether. Look for options like "Hardware Monitoring" or "Amp Monitoring" and ensure they are turned on.