Couple questions. Hadn't used my Stomp IO for awhile. Used it the other day just fine. I wanted to test how it worked with other software (BIAS, ReValver etc). Worked fine. Today I noticed in AT5 it wouldn't allow me to use "assign automation" anymore (it would auto assign pedals in stomp mode still though) so I could not assign it to turn off/on my way or control the wah swing. So... I looked on here and couldn't find anything about factory reset (or in the manual) but I did see one post where the IK guy said "repower on holding stomp 1 down because you might be in standalone mode." I figured maybe that could be my issue.... Well, after that my irig could not connect to AT5 and AT5 would say it can't find a Stomp IO. So, my two question are....
1) How do I factory reset my iRig Stomp IO because it no longer works?
2) For future reference, does using Stomp IO with other software assigning midi permanently change the MIDI settings on the iRig so that they're then different when you try to use AT5 again? Is this why I could no longer do "assign automation" in AT5 after trying those?
Thanks in advance.