Hey there my setup is AmpliTube 4 on windows laptop i5 -4300U with 8gb Ram Windows 10
and stomp I/O
When I switch presets, 1 out of 3 or 4 times there's a 3 or so seconds pause before it actually loads the preset.
I've tried lots of things like setting buffer to 1024 or even as high as 2048 and as low as 512 or even sample rate at 44100 @ 16 bit or 24bit and nothing works
On my desktop though, where I use the stomp I/o only as a usb "standalone" device and audio, inputs and outputs is handled by my focusrite scarlett, it works fine!
And I have set the buffer to like 64 @44.1k @ 32 bit !! Yes the desk is an i7 with 16g of ram but the desk runs a ton of things including Daw , games etc while the lappie is meant to only run Amplitube and is way more than the recommended specs...
Any ideas???????? I dont want to carry my scarlett around live and rehearsals...that';s why i bought the Stomp i/o and not a cheap Harley benton other midi/usb foot controller cause I wanted both the ease of control and the audio interface in one pack!
Any suggestions are more than welcome!