Stomp pedal to change presets in Amplitube 5

[Sharmon123@]

I have 3 presets that I would like to switch out during the song and I have a Win 10 setup but all the info on here seems to be iRig/Mac/Tonex. I am looking for a 3-4 button stomp pedal that works with an Axe I/O/Amplitube 5/Windows setup please.

[datkings]

I don't know too much...but I'll share what I know just in case it helps in some small way...

I don't have a specific pedal suggestion for you...but I think to change patches you will need a stomp that can send a MIDI signal into Amplitube on your PC.

I know you can change to a specific patch in Amplitube by sending a MIDI Program Change
Patch #1 = 000
Patch #2 = 001
Patch #3 = 002
etc

It sounds like you want a couple of footswitches to toggle "patch up" and "patch down" during a song. I don't know the specific MIDI command to do that...perhaps someone else on the forum knows that.

[Sharmon123@]

I am looking for something to change the tone for intro / main riff / outro with a foot switch when required. The presets are loaded in the control as #1 - #3 and now I need to map a foot switch to each. I am not and will never be a Brian May so 4 should be the max amount of buttons I need. Again it is a Windows 10 going into an Axe I/O install so nothing with an "i" before it please.

I am using a Boss FS-5U but that only increments through the whole list forward and only has 1 button.

[Sharmon123@]

Never mind I found one that works. Nektar Pacer on USB works flawlessly with Amplitube 5 EXCEPT the looper control only has play/stop/record. Youtube video on how to do it that I verified works with Amplitube v. 5.5.4 https://www.youtube.com/watch?v=MCfkftTp5xY

It is getting hard to find but a lot still available for about 240$ USD so a really cheap programmable foot board.