Amplitube 5 Glitch - Popping and Clicking

[dlmatera1994]

I'm getting an extremely frustrating issue where the Amplitube 5 Plugin in Ableton Live 11 repeatedly leads to clicks and pops between 6-10kHz (picture of the eq below, the tall skinny peaks are the guitar overtones while the fat rounded peaks are the cracks/pops). I've troubleshooted this and I'm sure it is not my guitar (I've tried many), my interface (I've tried many), chords, etc. - this problem does not occur if I turn the Amp off in Amplitube itself, or if I mute Amplitube plugin as a whole. Similarly, other amp modeling softwares have not recreated this issue. I have also tried reinstalling the software.



Image link if it doesnt load: https://ibb.co/RzzKw8h

Any advice? The software is essentially unusable with all of this popping

[650thunderbird]

Worth a try:
https://cgi.ikmultimedia.com/ikforum/viewtopic.php?f=5&t=28463#p122157

[dlmatera1994]

didnt work for me :{

[dcomara]

I was having an issue with pops as well as Im new to Amplitube and other amp sim plugins were not doing the same thing.. I finally figured out my issue was the amplitube mixer was clipping. Try opening the mixer section and check the levels on the effects bus and the master bus inside of amplitube. I had to lower the effects bus as it was peaking into the red. This solved my problem.

Hope this helps.

[bobaer]

In my case the clipping came from the ROOM mikes

[masxsim]

Solved! Press Cntrl-Alt-Del and run the task manager. Find Amplitube in the “Processes” tab, right click on it and find “Set priority”. It will be most likely set by default to “Normal” or “Below normal” and that causes clipping. Set it to “Realtime” and all clicks and pops should go away.
If you are running Amplitube as VST then it won’t show as a separate process, instead find the DAW you are using in the processes (anbleton live in my case) and set the highest “Realtime” priority for it.