How to make Tonex gain at 100% = Tone model default gain?

[javier.aldan]

I just captured my first tone model. The gain in the amp was at 3pm which is max usable gain. But now I find by default the gain knob at Tonex Editor is at 12 for whatever the gain was in the capture. This means if I crank the gain knob the tone model is pushed beyond the limit of a usable tone, just like the real amp.

This is what I need: I need the Tone Model to make the gain at 100% to match the gain of the capture. When the gain knob is cranked I get the maximum usable gain from the amp, if I roll it back I get lower but usable gain.

How to do this?

[yadirahyland]

Hello,
TONEX allows multi-profile captures via Advanced Training Mode. Here's how:

- Capture multiple gain levels:
- Set your amp to low gain, mid gain, and your desired max usable gain (3PM).
- Record each as a separate capture ("Tone Model Variant").

Use Advanced Training Mode:

- When you select multiple captures of the same amp, with varying gain, TONEX can intelligently interpolate between them.
- TONEX then remaps the gain knob so:
- Knob 0 = your cleanest tone
- Knob 10 = your 3PM capture