Having many issues using my Stomp with AT5 - have a ticket in but maybe someone has the same problems and figured out how to fix - probably something to do with my setup.
Starting the stand-alone always has the pop that says iRig Stomp I/O has just been plugged in do you want to connect to AT5 - manual and AT4 experience show this message should not display. I click on OK and after a few minutes of the screen graying out AT5 will finally display.
It then takes a few minutes to actually hear anything out of the monitors and if I change to different preset it indicates on the stomp to be on (green light) yet AT5 does not change even if I try with a mouse - program hangs up for a few minutes before responding.
Hopefully will hear from support soon.
Hardware:
Processor Intel(R) Core(TM) i5-6400 CPU @ 2.70GHz 2.71 GHz
Installed RAM 8.00 GB
System type 64-bit operating system, x64-based processor
Pen and touch No pen or touch input is available for this display
Display: 1920 X 1080
Norton 360 is the only other software running.
