How to delete single step during playback?

[Apogenic]

So I know how to delete whole sequence. That is Great. But how I delete or mute single note during playback? This is kind of very important thing during live jams. How do I do it?

Actually this will be helpful even during programming. Deleting everything and programming everything again just because you make one mistake seems counter-productive.

[Peter_IK]

Deleting a single step is covered in the manual section 7.1 - Step Recording.

You can download the User Manual from the UNO Synth product page (the "Manuals" link) or http://ikmanual.com/unosynth

[Apogenic]

Thanks. I did not know there is full manual online. I will check it now.

[Apogenic]

Deleting a single step is covered in the manual section 7.1 - Step Recording.

You can download the User Manual from the UNO Synth product page (the "Manuals" link) or http://ikmanual.com/unosynth

OK. I checked the manual and there is NO way to delete step during playback. On page 28 under 7.3 – Step Edit Recording there is: "To delete a step in this mode, simply press the down button." However this DO NOT delete step on my device but ONLY deletes stored parameter for this step but NOT whole step.

I conclude that there is no way to delete step during playback. Unless my device is faulty but I doubt it.

Please check it as this might be an error either in your manual or in software (or in my unit).

PS> I am just trying to help

[Peter_IK]

Deleting a single step is covered in the manual section 7.1 - Step Recording.

You can download the User Manual from the UNO Synth product page (the "Manuals" link) or http://ikmanual.com/unosynth

OK. I checked the manual and there is NO way to delete step during playback. On page 28 under 7.3 – Step Edit Recording there is: "To delete a step in this mode, simply press the down button." However this DO NOT delete step on my device but ONLY deletes stored parameter for this step but NOT whole step.

I conclude that there is no way to delete step during playback. Unless my device is faulty but I doubt it.

Please check it as this might be an error either in your manual or in software (or in my unit).

PS> I am just trying to help

At this point I would report this to IK Support as it should work as described in the manual. They will be able to assist further and see what's going on.