# Iloud sub session error saving after power on **URL:** \ **Category:** General Discussions\ **Created:** [June 17, 2026, 8:54am UTC](https://forum.ikmultimedia.com/t/iloud-sub-session-error-saving-after-power-on/487 "2026-06-17T08:54:54Z")\ **Posts on this page:** 3\ **Page:** 1
**Author:** ![mrmine75](https://avatars.discourse-cdn.com/v4/letter/m/ecccb3/32.png) [@mrmine75](https://forum.ikmultimedia.com/u/mrmine75)\ **Post date:** [June 17, 2026, 8:54am UTC](https://forum.ikmultimedia.com/t/iloud-sub-session-error-saving-after-power-on/487/1 "2026-06-17T08:54:54Z")
I purchased the Loud Sub, and I had set the settings and saved them in a session. Then, when I turned the sub back on, the settings were distorted in the sub zone. I also don’t understand why, if I try to save the session with other settings or take another measurement, the next session retains delays and phases that are sometimes strange. I can’t figure out the exact procedure. ---
**Author:** ![mrmine75](https://avatars.discourse-cdn.com/v4/letter/m/ecccb3/32.png) [@mrmine75](https://forum.ikmultimedia.com/u/mrmine75)\ **Post date:** [June 17, 2026, 9:49pm UTC](https://forum.ikmultimedia.com/t/iloud-sub-session-error-saving-after-power-on/487/2 "2026-06-17T21:49:18Z")
Ive found the problem.. When the button of correction active on the arc hardware is on the measurement and also the correction is compromised… I dont know if its abug or sonething else.. Can you check this? Thnks ---
**Author:** ![mrmine75](https://avatars.discourse-cdn.com/v4/letter/m/ecccb3/32.png) [@mrmine75](https://forum.ikmultimedia.com/u/mrmine75)\ **Post date:** [June 19, 2026, 8:16am UTC](https://forum.ikmultimedia.com/t/iloud-sub-session-error-saving-after-power-on/487/3 "2026-06-19T08:16:15Z")
hi again…i’ve done probably an error …i’ve used ik arc hardware correction togheter the iloud sub…perhaps this is my error…iloud has integrated the same dsp of ik arc 4? thnks